- This topic has 4 replies, 3 voices, and was last updated 12 years, 4 months ago by
.
-
Posts
-
Just recently changed brushes on this machine
Called back today with complaint poor spin
Tested with full load, machine spins until 7 minute remaining then returns to zero and stops.
Have cleaned armature, checked insulation okAny ideas please
Re: Bosch wf02264gb01 spin problem
Don’t forget if you set the ‘Spin Only’ cycle it only does a short spin and switches off anyway. Only on a full cottons cycle does it do a complete spin at all the various spin speeds.
PCB’s can get damaged by the armature insulation and an earth leak on the heater can also cause spin probs. So that gives you a few options to sort. 😀
Re: Bosch wf02264gb01 spin problem
It’s normal for the time to jump from 7 to 1min if your testing with no load because the machine has nothing to balance-out so it will just skip to 1min and carry on spinning, had me confused when I first noticed it. Maybe it could be down to unbalanced loads,not draining properly or the customer is just paranoid after the repair.
- You must be logged in to reply to this topic.