Cda648fw/1 beko fridge freezer

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Cda648fw/1 beko fridge freezer

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • November 22, 2013 at 11:42 am #78260
    mikeday1
    Participant

    Hi guys.

    Having a problem with this fridge. Customer complaining that the fridge is freezing on min setting.

    This is the one with the thermistors rather than thermostat.

    Anyone have any ideas.

    Regards
    Mike

    November 22, 2013 at 6:24 pm #405014
    Seamy
    Participant

    Re: Cda648fw/1 beko fridge freezer

    Maybe its getting low on gas & running continuously, is it actually below zero degrees in fridge or just a lot of frost on back wall?

    November 23, 2013 at 4:46 pm #405015
    mikeday1
    Participant

    Re: Cda648fw/1 beko fridge freezer

    Below 0 in fridge

    December 5, 2013 at 1:00 pm #405016
    Madmac
    Participant

    Re: Cda648fw/1 beko fridge freezer

    Have the same prob with a Beko CDA563FS, running continuously & freezing the fridge contents.

    Full electronic control on it, anyone know of a common failing on these causing this fault? It’s only around 3 yrs old.

    Thanks.

    November 19, 2016 at 10:09 am #405017
    A1applianceservice
    Participant

    Re: Cda648fw/1 beko fridge freezer

    Having the same problem with a Beko CDA648FW/1. Fridge contents being frozen. Engineer has replaced POT Board 4360635285, Module 4360620185 but fault persists. Engineer now wants to change the fridge sensor… lets see if this solves the problem! Does anyone have access to an exploded diagram?

    November 19, 2016 at 4:31 pm #405018
    Lawrence
    Participant

    Re: Cda648fw/1 beko fridge freezer

    If it’s not an American style then the sensor is foamed in

    November 19, 2016 at 8:16 pm #405019
    SAMURI
    Participant

    Re: Cda648fw/1 beko fridge freezer

    Fridge evap sensor or low on Gas is the only 2 possible problems.

    If the fridge evaporator is freezing evenly over the wet wall then the sensor is the problem.

    If the fridge evaporator is only freezing near the top then it’s low on Gas.

    Bob

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.