adg644 d/w

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › adg644 d/w

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • November 25, 2013 at 4:27 pm #78307
    clockworkone
    Participant

    Fault reported was 7 flashes e7.Inlet hose kinked and both filter on inlet valve and filter on hose at tap gunked up.put mc on test and ran till heated up with no problem.reset m/c and left. Cust rings later and tells me it seems to be stuck on drying cycle.she also tells me it did this before as well(could have told me this earlier)Dishes seem washed ok she says.Matrix seemed to be fine.could this just be a dirty owi sensor causing this.No error codes being displayed.Sorry misplaced service no.

    November 25, 2013 at 6:01 pm #405169
    deltra
    Participant

    Re: adg644 d/w

    Whirlpool 7flashes=flow meter!!

    November 25, 2013 at 6:47 pm #405170
    clockworkone
    Participant

    Re: adg644 d/w

    Thank you Deltra. Should have said that I cleared e7. Cleaned reed sw connections. No fault codes showing now.cust says it seems stuck on drying mode.I suspect it may still be stuck on wash program.Did not look when there but suspect if glass owi fitted that it may be dirty.

    November 25, 2013 at 7:33 pm #405171
    deltra
    Participant

    Re: adg644 d/w

    Also burnt and broken wires in door are a common prob

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.