- This topic has 5 replies, 3 voices, and was last updated 12 years, 3 months ago by
.
-
Posts
-
Hi, dryer runs clockwise ok for about4 mins. ( does heat up) stops,goes anti clock for a few turns stops,then won’t go clockwise again 😯 just sits there ❗ leave it like that and the tank light comes on…if I knock it off and start again it does the same!, any ideas ❓ Thanks
Re: Zanussi zdc37200 dies after 4 min
NTC at the front would be the first thing to check. Have you tried diagnostics to find out last error code recorded?
Re: Zanussi zdc37200 dies after 4 min
Hi martin, don’t know how to enter diagnostics!! Got no info on these at all. My thought was maybe reversing timer? Don’t even know if it’s got one,or is it all controlled by pcb?
Re: Zanussi zdc37200 dies after 4 min
Perhaps it’s best you email me and I can send you the service manual then. Be sure to remind me in the email what you’re after. 😉
Re: Zanussi zdc37200 dies after 4 min
Don’t think theres a reversing timer in this one, its a board controlled jobby.
They will normally run, heating for a few minutes then if the float switch is made they will knock off.
Check the float switch contacts as theres been an issue with them being problematic, also the NTC as mentioned before.
- You must be logged in to reply to this topic.