Whirlpool adg7470/1 8542 747 15001 Reset after fault

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Whirlpool adg7470/1 8542 747 15001 Reset after fault

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • January 7, 2014 at 6:59 pm #78905
    johnnyj
    Participant

    Hi guys was at a Whirlpool dishwasher error F08 and not draining i took a bit of glass out the pump, but i cannot get it to clear the fault according the instruction book the fault is not draining, blocked filters or syphon stuck once you have fixed open door press cancel/pause and close the door should clear the fault code but this bugger wont reset anybody any clues on this one.JJ

    January 7, 2014 at 7:52 pm #407329
    Criscold
    Participant

    Re: Whirlpool adg7470/1 8542 747 15001 Reset after fault

    Could try entering test program

    Press and hold program button for 5 seconds until 4 cycle LEDs light up
    Still pressing program button press the start button twice 2nd LED from left should light
    Release program button
    Service program should now start
    Now stored errors will be displayed
    After displaying errors ECO led will flash for 10sec and pressing select button should now delete stored errors.

    Good Luck

    January 7, 2014 at 8:04 pm #407330
    johnnyj
    Participant

    Re: Whirlpool adg7470/1 8542 747 15001 Reset after fault

    Cheers Chris i’ll give it a go

    January 8, 2014 at 8:31 pm #407331
    johnnyj
    Participant

    Re: Whirlpool adg7470/1 8542 747 15001 Reset after fault

    Chris you were spot on thanks very much, i tried pressing buttons on all sorts of ways trying to get it out.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.