Zanussi IZ141 anomaly

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi IZ141 anomaly

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • January 9, 2014 at 10:45 am #78934
    robstech
    Participant

    I have just completed a bearing and shaft replacement on a IZ141, on testing on spin cycle the machine takes in water whilst pumping and spinning, no error codes coming up. It does however complete a wash cycle with no apparent problem. How do you access the self disgnostics on this machine?

    Any help appreciated
    Robert

    January 9, 2014 at 12:47 pm #407423
    Martin
    Participant

    Re: Zanussi IZ141 anomaly

    Press and hold in the Start and the Skip button then turn on the On/off switch. To read of the last error detected you have to press the Fabrics or Temp button until the no9 LED lights.

    Though from what you tell us I don’t think this will help you. It’s possible you could have got water in the works or damaged a wire whilst doing the bearing job, do you think?

    January 9, 2014 at 6:09 pm #407424
    Seamy
    Participant

    Re: Zanussi IZ141 anomaly

    Check for chaffing of cable loom, damage to cables going to valves, pump, motor etc, sounds like there may have been a cable nicked or something. Check heater, motor for earth leakage also.

    January 17, 2014 at 4:13 pm #407425
    robstech
    Participant

    Re: Zanussi IZ141 anomaly

    Thank you both,

    checked heater,cables and ntc terminals, brushed off some carbon deposit from the module and everything is working normal now. ❗

    Rob

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.