Siemans D/W SN26M253GB/44 How To Release Module? – See Photo

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Siemans D/W SN26M253GB/44 How To Release Module? – See Photo

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 29, 2014 at 4:56 pm #79264
    laurenceuk
    Participant

    Hi,

    Not come across this type of Siemans D/w before with a heat exchange type impellor housing on the motor.

    Complaint of not heating(E09). Measured at plug with red leads – assumed as heater leads – no circuit. (see pic)

    How easy to change? Plus trying to get the module out to get at the motor I found that it seemed locked into the corner at the side and rear casing. I released it from the other points but it just pivots in that corner where it is hidden away by the base moulding.

    Is it just a clip that poking around with a long screwdriver will do the job?

    Any insights appreciated.

    Thanks.

    Laurence

    PS Ignore ‘Bosch’ on pic, it’s ‘Siemens’.

    January 29, 2014 at 5:49 pm #408632
    timdowning
    Participant

    Re: Siemans D/W SN26M253GB/44 How To Release Module? – See P

    There’s been a few posts of late about this style.
    The module will unclip with a bit of jigging. (Kettle lead out of the back, which I’m sure you’ve already done).

    You can then change the motor / heater assy from the same side.

    Make sure the new motor comes with a clamp.

    January 29, 2014 at 6:41 pm #408633
    Martin
    Participant

    Re: Siemans D/W SN26M253GB/44 How To Release Module? – See P

    Read this from the manual…….

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.