- This topic has 8 replies, 3 voices, and was last updated 12 years, 2 months ago by
.
-
Posts
-
Hi,
I’ve bought a new lower element for this oven, but am struggling to find a means to remove the old failed one. I’ve taken the oven out of the cabinet, removed the rear panel and can see the wires and the nut holding it in place. From there I’m stuck. At the back is just the insulating material and foil surround, so it looks like the element has to be removed through the front once the nut at the rear is undone. I’ve disassembled as much as I dare, but can find no means of getting to the element without completely taking the oven to bits. I feel it shouldn’t be that hard so reassembled and tried from the bottom. Again no luck.
Can anyone help, this is really frustrating!
Re: Ikea/Whirlpool lower element change FCVM6
I,d re-check the model number, or better still the barcode number beginning with 8
Re: Ikea/Whirlpool lower element change FCVM6
I suspect that if you move the insulation out the way all will become clear.
K.
Re: Ikea/Whirlpool lower element change FCVM6
Tried that to some extent, but it appears to be behind the foil as well, which looks sealed. I’m assuming this foil layer shouldn’t be broken at all?
Re: Ikea/Whirlpool lower element change FCVM6
Yes, 481925928847. I have it, just struggling to get the old one out!
Re: Ikea/Whirlpool lower element change FCVM6
Remove screws on far left and right.Wires off. Pull out. Element may be distorted causing snagging, but it will come out 😉
- You must be logged in to reply to this topic.