Siemens SN26M830GB/25 aborts half way through

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Siemens SN26M830GB/25 aborts half way through

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • February 11, 2014 at 5:14 pm #79482
    allan73
    Participant

    Hello all,
    The above dishwasher aborts approx halfway through a cycle and has twice brought up an E14 error which I believe is a flow meter fault.
    Qualtex have been unable to locate a flow meter on this machine for me and I’m wondering if anyone could shed any light on this ?
    Allan.

    February 11, 2014 at 7:36 pm #409419
    timdowning
    Participant

    Re: Siemens SN26M830GB/25 aborts half way through

    Have you been on Siemens spares site and looked at the exploded diagram for this model?

    February 11, 2014 at 7:59 pm #409420
    Martin
    Participant

    Re: Siemens SN26M830GB/25 aborts half way through

    timdowning wrote:Have you been on Siemens spares site and looked at the exploded diagram for this model?

    The thing is Tim that the Siemens site you refer to merely shows the exploded view and bugger all else. In truth it is pretty rubbish and only the official TRADE site is of any use.

    The flow meter is built in to the water inlet matrix and only the reed switch is available as a spare part (00611317). Fitting instructions below…… 😀

    February 12, 2014 at 8:17 am #409421
    allan73
    Participant

    Re: Siemens SN26M830GB/25 aborts half way through

    Thanks Martin, you succeeded where Qualtex tech dept failed.
    Allan

    February 12, 2014 at 10:22 am #409422
    allan73
    Participant

    Re: Siemens SN26M830GB/25 aborts half way through

    Is it common for the reed switch to fail part way into a cycle ?
    Allan

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.