CDA Dishwasher stops and flashes fault code

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › CDA Dishwasher stops and flashes fault code

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • April 4, 2014 at 9:27 am #80201
    MARIO
    Participant

    Hi been to a CDA cw494 dishwasher. Which is Whirlpool in disguise. Service code 8545 494 15610 Ser No. 33 0120 018252. Select program washes then after 20 minutes it pumps water out and beeps with the rinse light on which is the first light of the 5 program lights and the select program light far end flashing .Tried to find fault code and think it is flood protection but no leak .Can anybody point me in the right direction thanks

    April 4, 2014 at 9:53 am #412068
    electrofix
    Moderator

    Re: CDA Dishwasher stops and flashes fault code

    count flashes of the programme start button light. Can be up to about 15 flashes then a break then repeat

    Dave

    April 7, 2014 at 9:39 am #412069
    MARIO
    Participant

    Re: CDA Dishwasher stops and flashes fault code

    That is the problem the light is flashing continuous no sequence, but the program you select changes to rinse light lit when it goes into the fault condition.

    April 7, 2014 at 12:11 pm #412070
    electrofix
    Moderator

    Re: CDA Dishwasher stops and flashes fault code

    in any fault condition it goes back to first light ignor it its normal


    in this case you have fault 1 ntc failure

    one flash pause one flash pause etc so you cant see a sequence


    replace ntc if it goes ok if not its the board

    Dave

    April 19, 2014 at 9:18 am #412071
    MARIO
    Participant

    Re: CDA Dishwasher stops and flashes fault code

    Thanks for your help Dave

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.