Hotpoint BFI 620 dishwasher error code

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint BFI 620 dishwasher error code

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • April 10, 2014 at 10:03 am #80274
    Latham63
    Participant

    2nd led flashing. Locked,cant elliminate or change prog. Handbook suggests water load solenoid valve error? Inlet valve checks ok + salt container valve.
    Pcb?

    April 10, 2014 at 11:13 am #412322
    electrofix
    Moderator

    Re: Hotpoint BFI 620 dishwasher error code

    have you checked contiuity from board to valve

    not sure this will cause this fault but its woth a look

    Dave

    April 10, 2014 at 11:41 am #412323
    Latham63
    Participant

    Re: Hotpoint BFI 620 dishwasher error code

    Thanks will check that. But surely the machine should start up & drain before valve activates?
    Or do these machines just lock up if there is a fault.Reset does nothing!

    April 10, 2014 at 12:03 pm #412324
    electrofix
    Moderator

    Re: Hotpoint BFI 620 dishwasher error code

    the honest truth i am not sure. i would have thought it would have pumped first then failed

    had a few of these boards where the power supply cap failed on the board but most of the time it would start, fill and fail when the motor or heater kicked in

    have you tried to reset programme as these tend to start where they left off unless you reset them ?

    Dave

    April 10, 2014 at 1:14 pm #412325
    Latham63
    Participant

    Re: Hotpoint BFI 620 dishwasher error code

    Reset is normally press & hold start button for a few seconds.Or is there another procedure for these?
    The boards are about £85 retail for these.Did the board damage occur because of heater/motor earth fault?

    April 10, 2014 at 1:33 pm #412326
    electrofix
    Moderator

    Re: Hotpoint BFI 620 dishwasher error code

    no think its press and hold

    not heard of board being damaged by heater/motor earth faults at least not in houses with RCD’s fitted so things dont go bang

    Dave

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.