Zanussi W/D dead no lights

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi W/D dead no lights

  • This topic has 3 replies, 2 voices, and was last updated 12 years ago by pmb.
Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • April 10, 2014 at 3:29 pm #80279
    pmb
    Participant

    Zanussi intergratted Washer Dryer Emx14440w 914602300
    Power going in but dead and no lights, I think it most be PCB
    The part number is 973914602300001
    Does it come programmed ?
    This was a nightmare to get out, Kickplate jammed, drain hose to short and jammed behind intergratted dishwasher, European type sink waste connections which fell apart when touched,
    Recently made intergratted Machines the same Labour charge as freestanding,
    Not sure that was good idea.

    April 10, 2014 at 3:42 pm #412332
    Martin
    Participant

    Re: Zanussi W/D dead no lights

    You’ll need to quote for a PCB and an interlock at the very least before going further. Then time to whip out the PCB and check what blew it?

    Don’t envy you the task TBH. 🙁

    April 11, 2014 at 7:46 am #412333
    pmb
    Participant

    Re: Zanussi W/D dead no lights

    I did check the Interlock but do you think that might have blown the PCB
    If PCB is not pre programmed, I don’t wont to proceed.

    April 11, 2014 at 8:01 am #412334
    Martin
    Participant

    Re: Zanussi W/D dead no lights

    pmb wrote:I did check the Interlock but do you think that might have blown the PCB

    Always worth checking first!

    pmb wrote:If PCB is not pre programmed, I don’t wont to proceed.

    Is is already configured. (…..just plug it in, switch on, stand well back! :clown: )

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.