- This topic has 9 replies, 4 voices, and was last updated 11 years, 12 months ago by
.
-
Posts
-
Hello to all and ive got a problem! … I have the above machine for 3 years were well I thought the door lock has failed , so I got a new replacement which didn’t do the trick.
I then checked the wiring from the main board to the switch, all the wires checked out ok using my multimeter on continuity,e so with photos taken ive removed the main board to investigate.
Ive found a resistor on the board to be damaged , the tracks from this resistor lead to the door switch loom so it looks like the culprit but its so damaged I cant recognise it , its in the R369 position on the board and the board is a Delta EADP-C002-1 , ive also attached a photo to help identify the component
Any help would be great and thanks for having me here
Re: Hotpoint wmd942 doorlock issue
Now just have to hope that someone has a pcb they can have a look at to compare. This type of info is not supplied with any technical specs. 😥
Re: Hotpoint wmd942 doorlock issue
mark1983 wrote:yes it would be ashame , its been a good washer fingers crossed
It is a 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} Indesit made machine with very ropy electronics, a totally sealed drum etc.
I scrapped a Hoover machine this morning, the metal back panel had corroded through but it was 22 years old. that’s a good washer. 😉
I have a picture of a WMD960 pcb but it is completely different to that sadly.
Re: Hotpoint wmd942 doorlock issue
If you’re convinced the board has blown you could try Emw electronics that may be able to repair it for you, but as said these are poor quality machines. I seem to condemn an awful lot
Re: Hotpoint wmd942 doorlock issue
ok thanx for all replys still looking to identify the component in r369.
- You must be logged in to reply to this topic.