- This topic has 10 replies, 3 voices, and was last updated 11 years, 11 months ago by
.
-
Posts
-
Hi,
any help greatly appreciated. Thus far have tried:
inlet valves reading ~1.2Mohms therefore not OC
pressure switch contacts all OC until I blow into it the close
pressure switch pipe not blocked
filter not blocked
if left long enough then the Stain Removal, Easy Iron and Door lock lights flash continuously and the pump chugs continuously. That’s function control light 2 & 3 and door lock ;o) Only way to stop this is turn off electric at wall.
many thanks for any help,
Daz
Re: Indesit WIXL123 not filling
Nope Martin ;o)
Happy to do so. Can you explain the logic? Why if not filling with water might it be an issue with the brushes?
ta,
Daz
Re: Indesit WIXL123 not filling
OK, checked the brushes and there’s at least 1″ remaining on each of them.
Any other ideas?
much appreciated
Daz
Re: Indesit WIXL123 not filling
Lights 2&3 is F06, fault is supposed to be door lock related, door lock, wiring, pcb connections or even a pcb fault.
Re: Indesit WIXL123 not filling
thanks for the quick response iadom ;o)
I’ll check the connections (that I can). I do know that the lock works or at least, the light goes out and the door will not open. Then, after powering off the door lock clicks and door can be opened.
Daz
Re: Indesit WIXL123 not filling
sorry, wasn’t a criticism. Simply wanted to give all of the facts – like I should have done at the outset – doh!
;o)
Daz
Re: Indesit WIXL123 not filling
sniktaw wrote:sorry, wasn’t a criticism. Simply wanted to give all of the facts – like I should have done at the outset – doh!
;o)
Daz
No problem, I didn’t take it as a criticism, I was just pointing out that Indesit electronics are about the flakiest on the market and throw up all sorts of spurious codes. It is well worth giving the whole of the machine a once over with a megger to check for insulation leaks, especially the heater and motor.
- You must be logged in to reply to this topic.