- This topic has 4 replies, 3 voices, and was last updated 11 years, 10 months ago by
.
-
Posts
-
Hello,
the drum bearings on my Hotpoint WD51 are making a crunching noise and there is slight up and down movement of the drum relative to the drum casing. I am a ‘DIY white goods tinkerer!’, I’ve successfully replaced the bearings in an old hoover washing machine and our backup Electra 1000A but I’ve never tackled a washer drier and anything with a plastic drum casing. Does anyone have any advice regarding the method with this machine?
thanks.
Re: Hotpoint WD51 first edition drum bearings
We don’t go into ‘blow by blow’ instructions, we assume some level of competence. 😉
Basically though its front panel off, rear back panel off, split the outer drum front from the main outer drum and then follow your nose.
If the drum has as much play as you say it has and the bearings have been failing for some time then not only will you have great difficulty in removing the main, front bearing in one piece but it is highly likely that the drum support shaft/spider and even the outer drum bearing housing will be damaged.
I would attempt to strip it down first before you order any parts, it has a very high probability of being BER. 🙁
Re: Hotpoint WD51 first edition drum bearings
I was fearing that! That’s what finally saw off my tough old Hoover. The movement is very slight, hardly visable more of a noise so hopefully I’ve caught it in time?
- You must be logged in to reply to this topic.