- This topic has 4 replies, 3 voices, and was last updated 11 years, 8 months ago by
.
-
Posts
-
Hello,
I’ve been having an ongoing fight with an integrated Beko. The customer was complaining that it wasn’t draining, the there was water leaking out of it on the spin.
I had a look and the drain pump was knackered, so I changed it, had a cursory check for blockages, tested it and it seemed fine. A week or so later she was on the phone saying it had done it again on the 3rd load of washing she’d done that day (back from a holiday).
I’ve since had everything from the sump to the U bend off and there are no blockages, I checked the board and there are no signs of overheating on it.
I have only had it almost repeat the problem once – the pump was going, but it was very slow to drain. I’ve had it apart since then and she says it’s happening again…Has anyone else had a similar problem, or is this more likely to be a problem with the drains?
As always any help would be greatly appreciated.
Thanks
Grant
Re: Beko washing machine drain problem
Could it possibly be a sticking sump ball valve? Gloopy liquid detergent can make them stick and water can leak from dispenser….????
Re: Beko washing machine drain problem
I’ve had the ball out and is seemed fine – it’s worth a try, I’ll give it a good wash, or maybe just misplace it.
I’m sure the water is being thrown up the inlet pipe and out the dispenser. There is a bit of rust at the bottom edge of the dispenser and a clear run mark down the inside of the front panel.
Re: Beko washing machine drain problem
Button or coin in the drain hose ?
Had a few over the years. Keep bamboo stick in the van to prove them clear !
Does it go into a stand pipe or direct into the sink plumbing?
- You must be logged in to reply to this topic.