- This topic has 4 replies, 3 voices, and was last updated 11 years, 8 months ago by
.
-
Posts
-
got the above awaiting a repair. went thru it with a fine tooth comb.
replacing the pcb is a nono as its £300 just to have all the kit to do it.
found the transformer tf002 copper wire had burnt off from one of the main legs. resoldered a bridge and hoped itd be ok, and its still the same – dead F/F
tried looing online for a T/F that would match and not being experienced in this area, failed.
its a falco electronics ef16 1141 entry transformer.
can anyone sugest a place to source ?
and is it likely to have corrupted anything ? the rest of the board looks a1 bar some condensations soapy marks 😛
(photo attached)Re: hotpoint hm31aaf no start… pcb repair?
how about posting a few pics of the part and where it fits. looked online myself but as yet cant find any info on what this part does and cannot find any pics of the pcb
Dave
Re: hotpoint hm31aaf no start… pcb repair?
yes quality is a bit low
but from what i can see looks like it part of the power supply to the board. what has gone wrong with this transformer ?
Dave
Re: hotpoint hm31aaf no start… pcb repair?
As Dave says it does look like a SMPS power supply transformer, the image quality is too low for me to see anything properly but is there a fusible resistor on the board (in-line with the mains power to the board usually), if so check whether it is open circuit.
Give us a better quality image and then we may be better able to help you.
Jem
- You must be logged in to reply to this topic.