ZSF6160 powerswitch connectors

Hi

Just putting a Zanussi ZSF6160 dishwasher back togther and was plugging back in the front panel connectors after a board repair and heater replacement and realised I missed recording the powerswitch connections.

I dont think it falls into prohibited request of ‘re-wiring’ per se, so wondered how I can confirm the connector to plug pinout?

I have the 6 connecters on the powerswitch and 5 connectors with wires to plug on.

Tabs:

“rear”
1 2
3 4
5 6
‘Button’

I have 5 wires:

Black wire (unshielded connector) from lamp unit
Blue wire (unshielded connector)
Orange wire (white connector shroud)
Blue wire (white connector shroud)
Brown wire (white connector shroud)

Can anyone indicate what the pinout should be?

Usually I would record such obvious things but on this occasion it seems I was more concerned with getting the board repaired and parts and after several delays my short term memory is not helping!

I could make a fair stab at it but I would like to make sure I don’t screw it up further!

Thanks

Kevin