hja8362 dishwasher fault

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › hja8362 dishwasher fault

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 25, 2014 at 8:52 am #82357
    glennpunkuk
    Participant

    My dishwasher is draining fine. When the cycle switches on it just fills with cold water in the bottom of the dishwasher and nothing else happens, I’ve opened the front panel and set the cycle running again and noticed the element is heating the water but no further than the rubber hose at the front, there’s no hot pumping into the dishwasher its self at all.Any help would be appreciated as to its fault. Thanks

    September 26, 2014 at 8:29 am #419616
    Allsorts
    Participant

    Re: hja8362 dishwasher fault

    Is it heating the water to the point of getting warm or hot

    If warm the thermostat
    If hot then wash motor or PCB

    September 27, 2014 at 3:59 pm #419617
    glennpunkuk
    Participant

    Re: hja8362 dishwasher fault

    I set it to a 70 degree wash and the rubber pipe is really hot,there’s also being a slight smell of burning, like circuitry, could this be a good inclination of the pcb board?

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.