beko wm5100w problem

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › beko wm5100w problem

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • September 30, 2014 at 2:36 pm #82421
    mike1
    Participant

    hi,got a problem with the valve been sporadically energised
    at the end of the cycle,i have changed the pcb and tried a
    valve with no success,can anyone help thanks…mick

    September 30, 2014 at 5:10 pm #419799
    electrofix
    Moderator

    Re: beko wm5100w problem

    i am guessing a bit here but am i to understand the following

    tha machine goes through the programme and spins at the end only to fill up with water and wet the clothes again

    if so

    I had a beko that was connected to hot water doing that very thing.

    check for hot water inlet. if ok then look at poss ntc fault as i assume its the ntc thats sensing the overheat

    worth a try

    Dave

    October 1, 2014 at 8:03 am #419800
    mike1
    Participant

    Re: beko wm5100w problem

    no it doesn’t fill with water, it just makes a repetitive banging noise as the valve is sporadically energised.

    mick

    October 1, 2014 at 8:28 pm #419801
    codlets
    Participant

    Re: beko wm5100w problem

    Had the exact same problem on a wma hotpoint today. Although as soon as the door unlocks it stops. Will let you know if i find a solution !

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.