- This topic has 3 replies, 2 voices, and was last updated 11 years, 6 months ago by
.
-
Posts
-
I have a T270C which starts as normal – heats – drum turns. On any programme selection (Apart from cool air)after around 6 or 7 minutes the buzzer sounds continuously with the following lights.
Buzzer: constant light
Cool air: constant light
Hand iron: FlashingChecked airways and all pretty good condenser not perfect but clear enough. Almost seems like an overheat problem? Im only guessing because the one shot is still intact, is there a sensor I need to check and if so where the heck do I find it?
Many thanks for the shedload of instant responses 😆
Re: Miele T270c Error code help please
Instant I saw it I replied..
Hand Iron flashing denotes problem with the NTC temperature sensor in the fill ring, could be NTC faulty or cable to it or poor connections to board.
This NTC measures the drying air temperature, its mounted just below the filter on the right hand side.
It should read approx 12k at 25c.Re: Miele T270c Error code help please
I know I know …. Some people are SO impatient sorry Seamy haha. Thanks I am going back Tomorrow hopefully and will report back thanks again
- You must be logged in to reply to this topic.