Hotpoint CTD80 fault F15 on screen and is constant ON

Home › Forums › Public Support Forums › Help And Support › Tumble Dryer Help Forum › Hotpoint CTD80 fault F15 on screen and is constant ON

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 27, 2014 at 7:37 pm #82796
    shadowcorp
    Participant

    Hello, I have a hotpoint CTD80P and it was tripping the house due to a heating element issue (now fixed). but now I am getting an F15 error on the screen (that is quite dim) and when the dryer door is closed, the dryer works like it on a normal cycle (heats and spins) …even if I have not turned it on.

    how do I fix this? new top end PCB, or bottom side pcb, both, ect?

    pulling my hair out.

    October 27, 2014 at 8:28 pm #420835
    iadom
    Moderator

    Re: Hotpoint CTD80 fault F15 on screen and is constant ON

    The main power board is faulty, expensive and needs programming.


    Sent from my iPad using Tapatalk HD

    October 27, 2014 at 9:44 pm #420836
    shadowcorp
    Participant

    Re: Hotpoint CTD80 fault F15 on screen and is constant ON

    can I not get one from another dryer that’s going to end of life? or is each main board and display board married by code?

    October 27, 2014 at 10:42 pm #420837
    iadom
    Moderator

    Re: Hotpoint CTD80 fault F15 on screen and is constant ON

    Unless you can find one that is very near to your serial number then the chances are very remote. There are six different non interchangable versions of eeprom and the software. 😥

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.