Help replacing the door seal of Hotpoint WD41 Washer Dryer..

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Help replacing the door seal of Hotpoint WD41 Washer Dryer..

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • March 5, 2005 at 9:21 pm #8295
    akilgore
    Participant

    Hi folks,

    Wondering if anyone can help me changing the door seal on my aging WD41.
    The bit I’m stuck at is how to remove/disassemble the plastic “lock” on the outside of the door frame which seems to lock the (jubilee?) clip in place.

    Do I need a special tool…? 🙁
    I decided to post before using the universal tool – brute force… 😉

    Also, (several months ago) the same machine has refused to produce any heat whilst drying – this isn’t so much a problem now as we use a separate dryer but is still niggling me. Anyone tell me what’s the first thing I should check…?

    Many thanks,
    Andy.

    March 5, 2005 at 9:35 pm #127863
    clivejameson
    Participant

    Re: Help replacing the door seal of Hotpoint WD41 Washer Dry

    Hi Andy
    The door seal’s the easy bit…you need to carefully prise the wire over the edge of the seal. A small flat blade driver under the top part of it will do the trick.
    As to not heating on the dryer, the machine has overheat protectors on the hot air duct, these need to be checked first and if any are open circuit then the cause needs to be ascertained.

    March 5, 2005 at 9:39 pm #127864
    akilgore
    Participant

    Re: Help replacing the door seal of Hotpoint WD41 Washer Dry

    Thanks very much…
    So I just leave the wee plastic thing alone then…

    I assume it’s more or less the same procedure reversed to fit the new seal…

    Thanks,
    Andy.

    March 5, 2005 at 9:43 pm #127865
    clivejameson
    Participant

    Re: Help replacing the door seal of Hotpoint WD41 Washer Dry

    to refit…a careful twist will unlock the plastic clip, refit the band then squeeze to clip together again to tension it

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.