Whirlpool adp 8693 dishwasher

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Whirlpool adp 8693 dishwasher

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • November 11, 2014 at 11:14 am #82984
    cornflakes
    Participant

    unit appears to not heat up
    Runs constantly through programme With cold water.

    No error code showing
    Have stripped down unit, heater shows some resistance when tested for continuity

    Tried to see if voltage present at heater connections, nothing shows when programmed
    Other than E6 and E1 with heater out of circuit.

    Suspect it is the heater did not want to change if something else may be cause.
    Many thanks for any help
    Graham
    Leicestershire

    November 12, 2014 at 12:19 am #421341
    electrofix
    Moderator

    Re: Whirlpool adp 8693 dishwasher

    what resistance of the heater? if its under 100 ohms disconnected then its ok

    Dave

    November 13, 2014 at 10:55 am #421342
    cornflakes
    Participant

    Re: Whirlpool adp 8693 dishwasher

    Without returning and stripping down again
    I failed to note resistance
    Assuming the element is ok
    What else might be the problem
    Thanks

    November 13, 2014 at 1:44 pm #421343
    electrofix
    Moderator

    Re: Whirlpool adp 8693 dishwasher

    broken wires, relay on board inc blown track and solder joints, safety stats if fitted

    Dave

    November 13, 2014 at 9:40 pm #421344
    deltra
    Participant

    Re: Whirlpool adp 8693 dishwasher

    broken wires at bottom of door ,quite common on these

    November 14, 2014 at 4:14 pm #421345
    Grendal
    Participant

    Re: Whirlpool adp 8693 dishwasher

    You can meter the element from the pcb you should get approx 28 ohms. If that is ok it will be the pcb but would need the 85 number to get the correct part no

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.