Whilrpool AWO/D049

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Whilrpool AWO/D049

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • November 19, 2014 at 4:02 pm #83097
    novice1
    Participant

    Hi All, Please can someone help me before I pull out what little hair I have left. My whirlpool washer had a clean pump light come on mid cycle, so I read the instruction manual and it said press reset which I did. That was all ok then the next time I tried to wash something the clean pump and service light came on.So I stripped all the pipework from the pump to drain which was all blocked up and then I ran the machine again, same problem service light came on but now the machine won’t spin either. Anybody any ideas where I should try next? Thanks if you can help.

    November 19, 2014 at 5:57 pm #421748
    electrofix
    Moderator

    Re: Whilrpool AWO/D049

    if you did not do it first time clean the hose from the pump to the drum
    +
    there is a thin hose in the machine going from the bottom of the machine to an air operated switch. (dont blow into tube until you disconnect switch ans you can ruin some of them this way ) check this tube is clear also the bell it is connected to at the bottom
    theory is this. the machine may be empty but if the sensor is blocked it will think its full, so clean filter light and no spin

    Dave

    November 19, 2014 at 8:00 pm #421749
    novice1
    Participant

    Re: Whilrpool AWO/D049

    Hi Dave, tube at bottom clear, did you mean the tube to the pressure switch? cause thats clear to. Any other ideas?

    November 19, 2014 at 8:12 pm #421750
    novice1
    Participant

    Re: Whilrpool AWO/D049

    Just tried to start it and prewash/wash/rinse/service and start lights came on. Pressed reset the lights flickered but nothing else happened.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.