Bosch coding info

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch coding info

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • November 19, 2014 at 5:46 pm #83098
    winker
    Participant

    Can anyone supply me with the coding info for dishwasher
    SGS43E02GB/45.The cycle times are confused.

    thanks steve

    November 19, 2014 at 6:24 pm #421751
    Martin
    Participant

    Re: Bosch coding info

    Have you changed the control Unit then?

    November 19, 2014 at 9:44 pm #421752
    nomadPaul
    Participant

    Re: Bosch coding info

    If the cycle times have suddenly extended, i.e 199 mins for the quick wash , I’d be more entitled to think you’ve got a not heating fault.

    November 20, 2014 at 1:38 pm #421753
    winker
    Participant

    Re: Bosch coding info

    No i havent changed the control unit.But it was changed 4 months ago by a Bosch
    approved agent due to recall.The cycle time for quick wash 35 comes up at 142 mins instead of 30 mins and the other cycles are wrong.The heat is working as i found yesterday on test.The reported fault to attend was soap dispenser failing to open.

    November 20, 2014 at 3:47 pm #421754
    Martin
    Participant

    Re: Bosch coding info

    Dispenser solenoid corrupted the Control Unit probably.

    November 20, 2014 at 5:52 pm #421755
    winker
    Participant

    Re: Bosch coding info

    Martin,are you saying corrupted rather than blown and therefore recoverable by recoding.I found the dispenser would open on a prerinse and as previously stated
    machine does heat.Are there coding instructions available

    November 20, 2014 at 6:20 pm #421756
    Martin
    Participant

    Re: Bosch coding info

    Dispenser shouldn’t open in a pre-rinse, so perhaps the Control Unit was never configured from when the BSH contractors replaced it. I will dig out the coding instructions if you pm your direct email address. 😀

    November 20, 2014 at 7:57 pm #421757
    nomadPaul
    Participant

    Re: Bosch coding info

    Can you remember how long the pre rinse cycle was? It should only be 15-19ish minutes. If it was between 29 and 42 minutes then the cycles are definitely out of synch.

    November 22, 2014 at 5:41 pm #421758
    winker
    Participant

    Re: Bosch coding info

    Thanks to all senders of replies.will let you know outcome

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.