Beko dryer

This topic has 7 replies, 2 voices, and was last updated 11 years, 4 months ago by scottconers.

Viewing 8 posts - 1 through 8 (of 8 total)

Author

Posts
November 30, 2014 at 10:26 pm #83235

scottconers
Participant

Hi

I’m after a bit of advice I have a Beko drcs68w dryer that doesn’t heat up. I have tried the reset by pressing the start & cancel buttons together, I have replaced the heat element and the PCB but still no joy. When I do the reset/test clean filter and cancel flash but the filter is clean and clear.

I was wondering if anyone had any experience with this or any ideas of what it could be. I was wondering if there was a sensor that could be faulty.

Any advice gratefully revived.

December 1, 2014 at 1:06 pm #422155

lee8
Participant

Re: Beko dryer

Sensor fault.

December 1, 2014 at 1:34 pm #422156

scottconers
Participant

Re: Beko dryer

Would you know where it located?

December 1, 2014 at 2:28 pm #422157

lee8
Participant

Re: Beko dryer

At the front.

December 1, 2014 at 3:02 pm #422158

scottconers
Participant

Re: Beko dryer

Thanks. I take it’s the one at the top at the front.

December 1, 2014 at 3:50 pm #422159

lee8
Participant

Re: Beko dryer

Can’t remember to be honest.

December 1, 2014 at 4:42 pm #422160

scottconers
Participant

Re: Beko dryer

Is it the Beko NTC sensor?

December 1, 2014 at 5:58 pm #422161

lee8
Participant

Re: Beko dryer

Yup
Author

Posts

Viewing 8 posts - 1 through 8 (of 8 total)

You must be logged in to reply to this topic.