Beko dryer

Home › Forums › Public Support Forums › Help And Support › Tumble Dryer Help Forum › Beko dryer

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • November 30, 2014 at 10:26 pm #83235
    scottconers
    Participant

    Hi

    I’m after a bit of advice I have a Beko drcs68w dryer that doesn’t heat up. I have tried the reset by pressing the start & cancel buttons together, I have replaced the heat element and the PCB but still no joy. When I do the reset/test clean filter and cancel flash but the filter is clean and clear.

    I was wondering if anyone had any experience with this or any ideas of what it could be. I was wondering if there was a sensor that could be faulty.

    Any advice gratefully revived.

    December 1, 2014 at 1:06 pm #422155
    lee8
    Participant

    Re: Beko dryer

    Sensor fault.

    December 1, 2014 at 1:34 pm #422156
    scottconers
    Participant

    Re: Beko dryer

    Would you know where it located?

    December 1, 2014 at 2:28 pm #422157
    lee8
    Participant

    Re: Beko dryer

    At the front.

    December 1, 2014 at 3:02 pm #422158
    scottconers
    Participant

    Re: Beko dryer

    Thanks. I take it’s the one at the top at the front.

    December 1, 2014 at 3:50 pm #422159
    lee8
    Participant

    Re: Beko dryer

    Can’t remember to be honest.

    December 1, 2014 at 4:42 pm #422160
    scottconers
    Participant

    Re: Beko dryer

    Is it the Beko NTC sensor?

    December 1, 2014 at 5:58 pm #422161
    lee8
    Participant

    Re: Beko dryer

    Yup

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.