Whirlpool ADG 7470/1 – unable to reset

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Whirlpool ADG 7470/1 – unable to reset

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 9, 2014 at 7:21 pm #83353
    twicknix
    Participant

    This dishwasher has 8 flashes, found glass in pump, removed glass and cleaned it out. There were water on the base but the water was left standing for a long time, I don’t think there are other issues as I think it was overflowed when it tried to drain.

    I can’t reset it even turned power supply off. Unable to megger it as it’s hard wired. Wondering if it need overnight drying out before starting?


    Sent from my iPad using Tapatalk

    December 11, 2014 at 9:44 am #422548
    twicknix
    Participant

    Re: Whirlpool ADG 7470/1 – unable to reset

    Any info would be good as the customer is throwing a wobbler and threatening to buy a new dishwasher which I am reluctance to go down the route for number of reasons as one of them is time consuming and Christmas.


    Sent from my iPad using Tapatalk

    December 14, 2014 at 5:40 pm #422549
    twicknix
    Participant

    Re: Whirlpool ADG 7470/1 – unable to reset

    Oddly enough it cured itself after disconnection of 24 hours.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.