- This topic has 6 replies, 3 voices, and was last updated 11 years, 4 months ago by
.
-
Posts
-
I’ve got a 5/2 with an F08 fault which could be motor failure. Is it available still and how much?
Steve.
Re: ISE 5/2 motor.
I think we still have one or two but I’d need to check Steve and from memory they were about the £60 the last time we sold one.
K.
Re: ISE 5/2 motor.
Also a good chance that it is the inverter pcb that is at fault. 🙁
I think I have had one motor to five boards causing F08.
Also a pig to change, I do it without removing the drum as per the manual>
I lie it flat on it’s face with some cushioning on the floor and it is just possible to change it from underneath.Re: ISE 5/2 motor.
Went and tightened the loom connections and the machine spun up to high revs. Had an unsettling screaming from the motor when on high speed….. 😕
I’ve changed a couple of motors on these and they were difficult – but both done with the machine leant over sideways onto a plastic racking box.
Hoping it’s not PCB……………. 😥Steve.
Re: ISE 5/2 motor.
iadom wrote:Tried sideways, have a go face down, I promise you it’s easier. 😉
OK Jim, I’ll run that past the Mrs first……. :rotfl:
Steve.
- You must be logged in to reply to this topic.