- This topic has 8 replies, 2 voices, and was last updated 11 years, 3 months ago by
.
-
Posts
-
Seem to have an intermittent problem with this, since Xmas Day, when the machine stopped with a 3 beep error. I took it out and tipped it 45 degrees assuming the antiflood had activated. Machine then worked fine for a couple of days. I didn’t check bottom tray.
Now, the machine drains the water fine, pump stops, and you expect the fill to start. Slight pause, no fill and then back to drain cycle. This repeats until machine stops with a two beep error code.
Anti-flood hasn’t tripped as I have now removed cover and can see bottom tray.
Sometimes it will fill with water and run OK , until the next drain/fill cycle then same problem occurs.
Drain hose is clear, water supply OK.
Any ideas ?
Many thanks in advance
Re: AEG Favorit 34502VIO (911 539 114 00)
Gunge in the pressure switch.
Remove it, clean it out, and refit.
Re: AEG Favorit 34502VIO (911 539 114 00)
It can be accessed through the bottom front panel. Attached to the left hand side of the sump. Remove the plug connector and release the clip on top and it just pulls out.
Power off before going in.
Re: AEG Favorit 34502VIO (911 539 114 00)
Well thanks very much this seems to have done the trick.
There wasn’t much debris in there, but it was obviously enough to upset it.
Presumably I was correct in not separating the switch to clean it, it does look like it might come apart fairly easily?
Re: AEG Favorit 34502VIO (911 539 114 00)
Don’t have to take it apart. Just a flush out does the trick.
Re: AEG Favorit 34502VIO (911 539 114 00)
Now having another issue with this machine, it’s leaving a small amount of water in the bottom of the machine, just enough to cover the mesh grill. It’s probably only a few cup fulls if that.
Can anyone help please ?
Re: AEG Favorit 34502VIO (911 539 114 00)
This machine probably needs the pressure switch modification done.
- You must be logged in to reply to this topic.