- This topic has 4 replies, 2 voices, and was last updated 11 years, 1 month ago by
.
-
Posts
-
Hi, my oven and grill elements are not heating up. The fans and temperature neons are working fine. I have been reading the forums and deduct it is either the elements or the PCB. Where is the PCB located to check it and what is the best way to check the elements. Any info is much appreciated please.
Regards
PaulRe: SMEG SUK91MFX5 Oven and Grill not heating
board is this one
http://shop.ukwhitegoods.co.uk/81165019 … board-9164
it is unlikely 2 elements go down at the same time
look at the board and look for bad solder joints firstas far as i know this board is to allow 1 thermostat to control 2 oven elements. so it should no affect the grill
take a good look at the oven selector switch for bad contacts
Dave
Re: SMEG SUK91MFX5 Oven and Grill not heating
Hi Dave,
Thanks for your quick reply. Where is the PCB Control board located? I have looked at a couple of diagrams on the net, but none that I’ve found show it? I know from looking at one of the other posts on here relating to this oven there is a way to check (by moving a couple of the spade connectors) if the elements heat up. I just wanted to be sure before buying the replacement!
Kind regards
PaulRe: SMEG SUK91MFX5 Oven and Grill not heating
its at the back of the oven follow wires from fan elements
but as above dont think it controls grill
dave
- You must be logged in to reply to this topic.