- This topic has 8 replies, 4 voices, and was last updated 10 years, 11 months ago by
.
-
Posts
-
Good morning,
Could anyone let me know if there is a test sequence for the above washing machine?
The m/c will fill and briefly wash, before aborting with error E08
This relates to a motor/brush/ecu fault.
The m/c spins fine on fast spin, and is an induction motor, hence, no carbon brushes.
Hope someone can assist.
jonty
Re: Hoover DYN9164DPG 3100500913183080 Error: E08
Thank you so much simon26r,
Will carry out test procedure in the next couple of days.
Suspect motor…
jonty
Re: Hoover DYN9164DPG 3100500913183080 Error: E08
Well,
I carried out the test procedure… thanks Simon, which confirmed error code E08,(defective tachometric dynamo, wiring or electronic control module!) so visually inspected the motor, tacho, wiring and ecm.
All looked fine, so took a gamble and replaced the motor.
Re-tested on a wash programme, and all well for around 40 minutes until error code E08 returned.
Hence, I’m struggling to diagnose this fault… do these codes need cancelling via the diagnostic link in the ecm, and is there any way of testing the small module below the main ecm?
I’m wary of replacing the ecm, if it is not at fault.
jontyRe: Hoover DYN9164DPG 3100500913183080 Error: E08
Proved to be a fault in the electronic control unit.
Renewed, and all well.
jontyRe: Hoover DYN9164DPG 3100500913183080 Error: E08
Hi Jontymox with reference to your hoover e08
When you say electronic control unit do you mean the main board or the little box sitting in front of the main board, any chance of a part number?Re: Hoover DYN9164DPG 3100500913183080 Error: E08
Yes, main board was faulty.
Will try and locate part number, as it was over a year ago.
jonty
Re: Hoover DYN9164DPG 3100500913183080 Error: E08
The only part number I have is a Connect Distribution part no: 5045382385760
which I trust helps.jonty
- You must be logged in to reply to this topic.