Hoover WMH168D Fault Code E08 – HELP

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Hoover WMH168D Fault Code E08 – HELP

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 19, 2015 at 10:41 am #85868
    dalton565
    Participant

    Hi guys

    I have a Hoover WMH168D washing machine that has developed a fault and is showing E08 error code.

    The machine will fill and drain ok, but will not spin at all (No life whatsoever from motor). I have taken the motor out and examined the brushes and they are in good condition, and there is plenty left on them. I have tested the tachometer with a multimeter and it is showing correct resistance 43.7 and varing when spinning the motor.

    The machine is approx 3 years old and is only used lightly, it had a new PCB installed under warranty after about 6 months.

    Do you think the problem lies in the PCB or the motor or somewhere else maybe, parts are available pretty easily, new ones are a bit expensive so i was thinking of buying 2nd hand from ebay.

    All help appreciated

    August 20, 2015 at 7:53 am #429698
    Allsorts
    Participant

    Re: Hoover WMH168D Fault Code E08 – HELP

    Possibly the motor drive section on the pcb

    August 20, 2015 at 1:53 pm #429699
    dalton565
    Participant

    Re: Hoover WMH168D Fault Code E08 – HELP

    Thanks have order a new PCB so will give that a go and report back.

    I noticed a 2nd PCB device inside the machine, just under the lid on the right hand side do you know what this is for ?

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.