Neff R4381X1GB/04 (Dryer)

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Neff R4381X1GB/04 (Dryer)

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 9, 2015 at 7:19 pm #86055
    rocker
    Participant

    After some advice if possible, I am going to replace the bearings on this dryer, I have purchased the bearing set and the seal set for front. What I need to know what is the best way to remove the drum, Take the back off or the Front panel
    not sure which is best !! I am sure someone will know. thanks John

    September 10, 2015 at 11:27 pm #430188
    mikethemechanic
    Participant

    Re: Neff R4381X1GB/04 (Dryer)

    hi i remove the sides and back panel unhook the belt and take the drum out fit the new seal and bearing then rebuild do not take the front off
    good luck

    September 14, 2015 at 9:12 pm #430189
    rocker
    Participant

    Re: Neff R4381X1GB/04 (Dryer)

    cheers mike, will give it a go. john

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.