indesit wd12uk fault code 3 flashes

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › indesit wd12uk fault code 3 flashes

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • March 21, 2005 at 9:03 pm #8614
    admin
    Keymaster

    replaced burnt out control module on this machine now it is showing error code 3 anyone any suggestions?

    March 21, 2005 at 9:27 pm #129616
    Penguin45
    Participant

    Re: indesit wd12uk fault code 3 flashes

    Check that the temperature sensor is in circuit and giving a reading in Kohms. Also check for correct positionong on new circuit board.

    Pull the plug first :plug: .

    Regards,
    Penguin45.

    March 21, 2005 at 10:58 pm #129617
    admin
    Keymaster

    Re: indesit wd12uk fault code 3 flashes

    will check temp sensor as for positioning on new circuit board from what i remember the plugs can only go on in one order cant they?

    March 22, 2005 at 12:22 am #129618
    Penguin45
    Participant

    Re: indesit wd12uk fault code 3 flashes

    In theory……… :rotfl:

    Diagram always best course of action.

    Luck, regards,
    Penguin45.

    March 29, 2005 at 10:17 pm #129619
    admin
    Keymaster

    Re: indesit wd12uk fault code 3 flashes

    FOUND THE PROBLEM WITH THE NEW BOARD TOOK IT OUT TO INSPECT AS CHECKED THE SENSOR AND WAS OK,WHILE LOOKING AT THE BOARD NOTICED THE NEW BOARD HAD AN IC HOLDER BUT NO IC IN IT DESOLDERED THE ONE FROM THE OLD BOARD PUT IT IN THE NEW BOARD AND IT WORKED.QUESTION IS DO THESE CONTROL BOARDS ALWAYS COME WITHOUT THIS IC,USED TO SERVICE WHITE GOODS 10 YEARS AGO SO MACHINES HAVE OBVIOUSLY CHANGED ALOT SINCE THEN,THIS WAS DONE AS A FAVOUR FOR A FRIEND BUT I PRESUMED WHEN I ORDERED A NEW CONTROL MODULE IT WOULD HAVE BEEN COMPLETE AND JUST A STRAIGHT SWAP

    March 29, 2005 at 11:21 pm #129620
    Penguin45
    Participant

    Re: indesit wd12uk fault code 3 flashes

    Ah, yes, the EPROM……. Don’t tell you that do they? No little service sheet to say “Swap the EPROM over”.

    That’s The Indesit Company for you…………….

    Glad you resolved it.
    Regards,
    Penguin45.

    March 30, 2005 at 9:40 pm #129621
    Flyman
    Participant

    Re: indesit wd12uk fault code 3 flashes

    Latest machines now come with very small surface mounted eprom. If you order a new module it will come with a socket for the standard size eprom, which you will have to order as an extra 😕 Same on the new Hotpoints.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.