- This topic has 5 replies, 3 voices, and was last updated 10 years, 6 months ago by
.
-
Posts
-
Hi,
An Electrolux clone.It is overfilling, but can not find
a pressure switch or flow meter.
Or anything else. How does it Know?Any ideas?
Cheers in advance.
Re: Neue dishwasher
Soppy little pressure switch fitted to these and most very late Lux dishwashers…..
Completely empty all water from the sump; remove door skin; unclip plinth front cover, remove plinth frame. Look at the sump unit and just to the left of centre and up under the tub you will see two very thin wires go up to a little item pushed into the side of the sump; it is white plastic, about 5cm long and has a dome in the middle. It is secured to the sump with a small plastic barb that has to be prised downwards and the pressure switch can be slid out and unplugged from loom.
Clean out the hole into the sump, the rubber gasket and try to clear the switch by tapping the open end onto your palm. Sometimes food bits come out and the switch can be saved, sometimes not. Fortunately, they are quite cheap and quite fallible so that’s good news….. 😉 I am now keeping this item as van stock as I’ve had several fail and they seem to be regular fit to Lux based stuff.
Hope that helps,
Steve.
neue dishwasher
Hi,
At first this was overfilling, so replaced pressure switch,
as advised on here,thanks.
Now it fills correctly, but will not heat.
Thermister seems ok, no burn ups on pcb.Oh and heater Ok, no mains to it.
Any ideas?
Cheers in advance.
Dena89.
- You must be logged in to reply to this topic.