- This topic has 6 replies, 4 voices, and was last updated 21 years ago by
.
-
Posts
-
Proline frost free freezer, working ok but fan not running.
There is no excessive ice build up on the evaporator and the fan is free running, this is as far as i got as i was there doing something else plus i was on a meter 😀
Would this be the fan or the electronickey bits?Ray
Re: One for the Comet guys…Proline FF959 Freezer
Looking at the wiring diagram (it’s a Brandt by the way) the fan motor is supplied directly from the PCB so if the fan motor isn’t faulty it can’t be much else really.
Unless a faulty thermistor is causing the error, there’s two of them, described as temp probe and defrost probe.
Dave.
Re: One for the Comet guys…Proline FF959 Freezer
The last 3 appliances with fault I have been to has turned out to be the PCB,You can check that there is or isnt power coming out from the PCB from the front at the PCB connections.
Bryan :wave:
Re: One for the Comet guys…Proline FF959 Freezer
Thanks for the input!…i can leave the hairdryer on the van then 😆
Ray
Re: One for the Comet guys…Proline FF959 Freezer
oops..forgot to ask how much the PCB bit is and the best place to get one?
been mugged by Comets in the past…Ray
Re: One for the Comet guys…Proline FF959 Freezer
£45 plus VAT ray (includes carriage).
Not too bad as Brandt prices go 😉
I can get if required for you.
Dave.
Re: One for the Comet guys…Proline FF959 Freezer
There are 2 pcb’s that were fitted during production, they are interchangeable but the wiring may need to be extended.
45×9781 has the terminals on the left side of the board and led’s on the right
45×8357 has both the terminals and the led’s on the right of the board
Hope that helps
Clyde 8)
- You must be logged in to reply to this topic.