Zanussi dryer cutting out.???

This topic has 3 replies, 2 voices, and was last updated 10 years, 6 months ago by iadom.

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
September 28, 2015 at 7:24 pm #86224

iadom
Moderator

ZDC47100W. Pnc: 916094517/09

Tried it without clothes but set to a timed dry period. As the customer stated the dryer stopped completely after about five or six minutes. Switched off and then switched back on within a few seconds and it started to run once again, tumbling and heating correctly so don’t think it could be motor overload related.

Tried to run diagnostics but got a strange ‘non error code’

The start button is flashing between red & green with virtually no pause, just red/green , red/green continuously.

Condenser etc all clear.

Any thoughts?

October 1, 2015 at 8:21 pm #430588

Seamy
Participant

Re: Zanussi dryer cutting out.???

Heater goes out on them sometimes if dryer is used constant without cool down period. NTC needs to cool down.
Check rear felt bearing/seal, if its off or distorted air from fan is not directed over heater and again heater goes out, open circuit but this normally throws up a fault E62

October 1, 2015 at 8:28 pm #430589

iadom
Moderator

Re: Zanussi dryer cutting out.???

Thanks Seamy, machine is in a garage and AFAIK they don’t stop it mid cycle.

Any reason why the diagnostics wouldn’t run correctly, it just flashes red/green continuously without a pause???

Jim.

October 2, 2015 at 6:46 am #430590

Seamy
Participant

Re: Zanussi dryer cutting out.???

iadom wrote:Thanks Seamy, machine is in a garage and AFAIK they don’t stop it mid cycle.

Any reason why the diagnostics wouldn’t run correctly, it just flashes red/green continuously without a pause???

Jim.
Diagnostics may not run correctly if it has not been selected correctly, corrupt board, short circuit of component etc
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.