Bosch motor tacho fault?

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch motor tacho fault?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 29, 2015 at 12:45 pm #86233
    iadom
    Moderator

    WFLI2440GB/18

    Due to installation and time constraint I wasn’t able to extricate the machine from under the worktop.

    Set to spin and it is obvious the motor is not under control, ramps up fast then cuts out then repeats this.

    Removed lower front panel to inspect motor wiring which appears to be intact.

    Not encountered this on a Bosch appliance before, as the electronics are obviously sensing the fault and cutting the power does this point to a motor/tacho fault and would that involve a new motor?

    Jim.

    September 29, 2015 at 1:46 pm #430601
    electrofix
    Moderator

    Re: Bosch motor tacho fault?

    had a few where the magnet had split in half

    managed to extract it from a scrap motor and refit it.
    its a bit difficult because its behind the back bearing

    Dave

    September 29, 2015 at 3:34 pm #430602
    iadom
    Moderator

    Re: Bosch motor tacho fault?

    Thanks Dave.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.