Dishwasher

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Dishwasher

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • October 4, 2015 at 12:35 pm #86286
    MichaelTLynock
    Participant

    I have a Lamona (HJA8631) dishwasher. Initial start-up is fine. It fills, heats, rinses, then drains, and drains, and drains. The thing tends to go on indefinitely if I didn’t switch it off. It appears ok for the first part of the programme but draws a halt after the first rinse. Should I be looking at a new PCB or what?

    Any help would be gratefully appreciated.

    Mike

    October 4, 2015 at 1:35 pm #430717
    simon26r
    Participant

    Re: Dishwasher

    Hi. Please first check that the base of the machine is not full of water. (Not the area that you load with plates ect) sounds to me like the main pump has a leak. Normally made by beko. I do have a cheap pump going if its that.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.