- This topic has 3 replies, 3 voices, and was last updated 10 years, 5 months ago by
.
Viewing 4 posts - 1 through 4 (of 4 total)
-
Posts
-
Zanussi 2 year old washer. zwg6141p 914906015/02. Had a look at this one today. Completely dead. Power to control board. No signs of damage or burning. Has anyone come across these issues on these.
Re: zwg6141p
dont this board but sound like it might be power supply chip on board. may also be scrap but the chips are cheap if you can solder
look in the simple pcb repair tip at top of this forum
Dave
Re: zwg6141p
just a thought have you checked the the knob shaft is actually actuating the potentiometer (program selector component) on the module? take facia off, pop out knob and stick a kebab stick in it and see if it then turns on. Had a tribendix a few years back fail on delivery because the black peg that linked the twn wasnt in there.
Viewing 4 posts - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.