zwg6141p

[clockworkone]

Zanussi 2 year old washer. zwg6141p 914906015/02. Had a look at this one today. Completely dead. Power to control board. No signs of damage or burning. Has anyone come across these issues on these.

[electrofix]

Re: zwg6141p

dont this board but sound like it might be power supply chip on board. may also be scrap but the chips are cheap if you can solder

look in the simple pcb repair tip at top of this forum

Dave

[gandh1]

Re: zwg6141p

just a thought have you checked the the knob shaft is actually actuating the potentiometer (program selector component) on the module? take facia off, pop out knob and stick a kebab stick in it and see if it then turns on. Had a tribendix a few years back fail on delivery because the black peg that linked the twn wasnt in there.

[clockworkone]

Re: zwg6141p

Many thanks for replies. Can see shaft turning at rear of control panel. Will take board out and bring into guy that does any electronics for me.

[Author]

Posts