siemens d/w no display

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › siemens d/w no display

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 13, 2016 at 7:05 pm #87305
    clockworkone
    Participant

    se26n250gb/11. This dishwasher is not powering up at all. Checked on/off button. power going to board. It went mid wash. Don’t know a lot about this one to be honest and would appreciate any advice. Paul

    January 13, 2016 at 10:02 pm #434463
    melec
    Participant

    Re: siemens d/w no display

    by operating the aquastop float switch this should power up pump which points to module failure
    Might be worth trying a continuity check on the Door micro also
    If the aquastop test does not run pump when door open the switch proved
    Methinks it’ll run door open or closed though

    January 13, 2016 at 10:05 pm #434464
    melec
    Participant

    Re: siemens d/w no display

    That should read ‘ then pump proved’
    It is usually module never a door switch but still have to check of course

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.