Hotpoint AQXXF149PMUK

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint AQXXF149PMUK

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 30, 2016 at 11:52 am #87452
    A1applianceservice
    Participant

    Hi
    I have a customer with one of these HP washing machines with a reported F05 fault.
    I went and had a look and found it was full of water but unable to start or switch the machine off from the facia and no door lock light on the display. The filter was badly clogged. Upon clearing filter managed to get the interlock to work after several attempts and pump kicked into life. Tried on wash cycle but will not fill even with the lock light on. More blockages in sump or pressure switch tube ?
    Can anyone advise what may be causing this (PCB ??)
    Thanks, await your reply.
    Regards,
    Jaz

    February 1, 2016 at 8:27 am #434889
    wilf
    Participant

    Re: Hotpoint AQXXF149PMUK

    had the same thing on one of these last year cleared the pump it then pumped then nothing put it down to pcb as everything else tested ok. horrible machines thankfully not too common.

    wilf

    February 2, 2016 at 8:46 pm #434890
    whitevanman
    Participant

    Re: Hotpoint AQXXF149PMUK

    did u recalibrate psw with 1.5 litres of water down soap drawer?

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.