- This topic has 1 reply, 2 voices, and was last updated 10 years, 2 months ago by
.
-
Posts
-
Model AWZ612
Called recently to a no heat on drying cycle
Found resettable TOC open circuit
Reset. Unit producing heatRemoved heat chamber cover to check for blockage..clean
Checked air inlet to drum. Again clear
Air fan running
Ran dryer cycle all ok.Client rang today again no heat on dryer
Asked her about load size..says just a normal basket full?Any ideas where to check out next
Thermostats etc
Or has resettable TOC failedMany thanks
Graham
Re: Whirlpool washer dryer
Smeg model that one. Usual reasons are blocked fan blade (fluff in the gaps between the blades), no water inlet on dry, front drier ntc (in bellows between heater and door seal) covered in fluff upsetting its readings. Have also had fan motors intermittent start up- just sit there humming instead of spinning and next 10 times will work fine or as you suggested, faulty resettable toc or connectors producing its own heat.
- You must be logged in to reply to this topic.