beko drvt71w belt replacement

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › beko drvt71w belt replacement

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • February 12, 2016 at 5:59 pm #87584
    slyp98
    Participant

    hi all had one of these beautys with the small motor belt burnt out , i have the new belt but i found it impossible to fit the large drum belt back in place it needs to be stretched way too much so much so that i broke the plastic motor bearing cap anyone have any info on these thx

    March 4, 2016 at 6:23 pm #435325
    baileyjdm
    Participant

    Re: beko drvt71w belt replacement

    This is surely a machine with a sprung motor that you crank over and release once the belts over the pulley?

    March 8, 2016 at 8:34 pm #435326
    slyp98
    Participant

    Re: beko drvt71w belt replacement

    thats the one ,easier said than done though , through the small hatch at the back for the vent cover !!

    March 8, 2016 at 9:31 pm #435327
    garn
    Participant

    Re: beko drvt71w belt replacement

    Make 1 of these.c00098111 old Hotpoint Ariston creda belt fitting tool locate the ring And weld the ring washer further up the shaft. its still tight to slide the belt down a bit but it does work on the job and saves a sweat on 😉

    Its Save the Trauma of using a very long screwdriver and a crowbar and Claret dripping on the customers floor .

    Garn

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.