Hotpoint induction motor PCB

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint induction motor PCB

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • July 1, 2016 at 11:49 am #88685
    Madmac
    Participant

    Have a MK6 board on a WMD 960p which does nothing beyond locking the door and sitting silent. Customer says it will flag a spurious error code if left powered up for ages.

    I think this is a common failing on these machines but as it belongs to a penniless old biddy I wondered if anyone knew if there was a specific component on the board which typically causes these symptoms ?

    Certainly cant see anything obvious like a swollen cap or whatever.

    Thanks, Ed.

    July 2, 2016 at 6:02 pm #438988
    char14lew
    Participant

    Re: Hotpoint induction motor PCB

    have you checked the drain pump and inlet valve?

    July 4, 2016 at 7:51 pm #438989
    Madmac
    Participant

    Re: Hotpoint induction motor PCB

    yep, checked all the basic stuff. It’s a fault I’ve seen before on these boards and usually just get one from EMW but that means a £60 bill in parts alone for my elderly customer.
    Trying to keep the cost down for her.

    Thanks for the reply 🙂

    Eddie.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.