Hotpoint induction motor PCB

[Madmac]

Have a MK6 board on a WMD 960p which does nothing beyond locking the door and sitting silent. Customer says it will flag a spurious error code if left powered up for ages.

I think this is a common failing on these machines but as it belongs to a penniless old biddy I wondered if anyone knew if there was a specific component on the board which typically causes these symptoms ?

Certainly cant see anything obvious like a swollen cap or whatever.

Thanks, Ed.

[char14lew]

Re: Hotpoint induction motor PCB

have you checked the drain pump and inlet valve?

[Madmac]

Re: Hotpoint induction motor PCB

yep, checked all the basic stuff. It’s a fault I’ve seen before on these boards and usually just get one from EMW but that means a £60 bill in parts alone for my elderly customer.
Trying to keep the cost down for her.

Thanks for the reply 🙂

Eddie.

[Author]

Posts