samsung WD8704 pump problem

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › samsung WD8704 pump problem

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • July 13, 2016 at 10:21 am #88773
    electrofix
    Moderator

    got a Samsung
    WD8704RJA / XEU03
    y05754ab200429j

    Set machine on a spin only cycle

    pump try’s to start but does not. if you leave it running pump gives a flicker every now and then.
    have checked pump for wear and given it a push with a screwdriver but its evident there is no power getting to the unit

    I am assuming power board but having experience of the hot point problem with the TD ntc causing the same fault thought I would see if anyone else had any experience of this

    Dave

    July 14, 2016 at 6:58 am #439336
    wilf
    Participant

    Re: samsung WD8704 pump problem

    have you tried putting water into the drum to reset pressure switch ?
    wilf

    July 14, 2016 at 7:07 am #439337
    electrofix
    Moderator

    Re: samsung WD8704 pump problem

    no is there a procedure for that ?

    would not have thought it would have been relevant on the spin programme but then electronic machines can be silly.
    anyone got any tech info ?

    dave

    July 14, 2016 at 7:36 am #439338
    Lawrence
    Participant

    Re: samsung WD8704 pump problem

    Thats a weird one Dave ,check the loom feeding the pump hint chafed ,and I have known poor crimp terminals,I assume you’ve got 240 at the pump ? they are just a normal askoll pump so nothing clever,otherwise yeah its the board and you need the part number off the board itself

    July 14, 2016 at 7:47 am #439339
    electrofix
    Moderator

    Re: samsung WD8704 pump problem

    thanks maybe worth a revisit to check the leads because board not too cheap

    Dave

    July 18, 2016 at 10:59 am #439340
    WhiteVanMan1
    Participant

    Re: samsung WD8704 pump problem

    I’m sure you will be aware, but just in case, I went to one of these, not sure if it was the same model, but there is a switch on the filter door. Steve.

    July 18, 2016 at 5:38 pm #439341
    electrofix
    Moderator

    Re: samsung WD8704 pump problem

    thanks for your input

    went out to panasonic like that but no switch on this one

    went out again today checked all connections and put a volt meter on leads

    its a board fault so customer is going to replace is as connect want £130 + vat +carr for the board

    Dave

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.